RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 15
1
2
3
11
Last »
Search: Posts Made By: kiosk
Showing results 1 to 25 of 362
Search took 0.70 seconds.
Forum: ARF or RTF
04-02-2012, 08:41 AM
Replies: 710
Views: 110,459
Posted By kiosk

RE: Great Planes Extra 300 GP/EP

i found one from here but dont remmember what size it was....if you measure yours u should be able to find it with the right diameter just cut to lenght

http://www.mcmaster.com/
Forum: ARF or RTF
04-02-2012, 08:38 AM
Replies: 710
Views: 110,459
Posted By kiosk

RE: Great Planes Extra 300 GP/EP

i went electric with mine....love it, tons of power on 5-cell setup.....
Forum: ARF or RTF
08-01-2010, 08:30 AM
Replies: 710
Views: 110,459
Posted By kiosk

RE: Great Planes Extra 300 GP/EP

I use clear ultracote light....works like a charm
Forum: JR Radio & Spektrum Radios
08-01-2010, 08:25 AM
Replies: 193
Views: 24,687
Posted By kiosk

RE: Which JR\Spectrum receiver did you crash with?

spektrum/JR receivers have failed, and will fail.....there is no argument to that, period....it might be a small amount but it happens nevertheless..... this for all you JR "enamored" folks give it...
Forum: ARF or RTF
01-27-2010, 08:38 AM
Replies: 1,405
Views: 277,849
Posted By kiosk

RE: Hangar-9 Sopwith Camel Build Thread

i think i am going to burn this thing down....no matter how smooth a landing I cant keep it from flipping over the nose as it rolls to stop.....I cant figure it out and sick of it.

is as if the...
Forum: ARF or RTF
01-12-2010, 01:44 PM
Replies: 710
Views: 110,459
Posted By kiosk

RE: Great Planes Extra 300 GP/EP

anyone? c'mon, am gettin depressed over here!!! need/want this plane!
Forum: ARF or RTF
01-07-2010, 12:59 PM
Replies: 710
Views: 110,459
Posted By kiosk

RE: Great Planes Extra 300 GP/EP

am ready to pull trigger on this one, has anyone gone electric can they post their setup?
Forum: ARF or RTF
12-30-2009, 08:55 PM
Replies: 1,405
Views: 277,849
Posted By kiosk

RE: Hangar-9 Sopwith Camel Build Thread

i just got one of these previously owned....took it up yesterday and boy was it a handful!!! ran out of down trim wanted to pitch up so bad, I think decalage issue of some sort havent checked...
Forum: Gas Engines
12-25-2009, 04:48 PM
Replies: 1,358
Views: 232,822
Posted By kiosk

RE: GAS Saito

check out thread on flying giants, u might get better answers there....

http://www.flyinggiants.com/forums/showthread.php?t=45623
Forum: RC Warbirds and Warplanes
12-25-2009, 04:45 PM
Replies: 2,861
Views: 381,215
Posted By kiosk

RE: New Hangar 9 1.50 P-51 Build

i agree with everything except is underpowered......that is not for an H9 P51.....


ALWAYSPDG, I would only do it again because of the sound, is very unique and perfect for a warbird, cant...
Forum: RC Warbirds and Warplanes
12-22-2009, 05:48 AM
Replies: 2,861
Views: 381,215
Posted By kiosk

RE: New Hangar 9 1.50 P-51 Build

i always use a digital metal gear servo and arm on ALL aileron surfaces of my scale birds, is worth the extra cost...you can lose a rudder or elevator servo and make out ok, but losing an aileron...
Forum: Twin & Multi Engine RC Aircraft
12-09-2009, 06:01 PM
Replies: 1,122
Views: 193,021
Posted By kiosk

RE: Seagull's

it can be done but not sure on this bird, also depends on wind conditions and other factors also, the dual ace just aint got a big enough rudder to counter torque at low airspeed of (a rather...
Forum: Twin & Multi Engine RC Aircraft
12-09-2009, 10:51 AM
Replies: 1,122
Views: 193,021
Posted By kiosk

RE: Seagull's

try a go around after an aborted landing on one engine.....bet you wont think the same!
Forum: Gas Engines
10-24-2009, 04:33 PM
Replies: 1,358
Views: 232,822
Posted By kiosk

RE: GAS Saito

thats good idea, i've been trying to duct some air for my FG36 inside the tight H9 P51 cowl, but havent figured out how to build this ducting...what did you use?

while i agree cooling the cyl...
Forum: RC Warbirds and Warplanes
10-24-2009, 08:16 AM
Replies: 2,861
Views: 381,215
Posted By kiosk

RE: New Hangar 9 1.50 P-51 Build

yea that was a turn off from me when I was considering this model too....the nose drop is too sharp to meet the spinner.....the scale P51 ot H9 arent like that, not sure what were they...
Forum: Giant Scale Aircraft - General
09-17-2009, 09:18 AM
Replies: 3
Views: 1,315
Posted By kiosk

retract cylinder...what grease?

after ditchin in mud/dirt, had to take robart air retracts apart for some serious cleaning, does anyone know what grease is used inside the air cylinder in the retract? it looks like white lithium...
Forum: Gas Engines
09-14-2009, 08:27 PM
Replies: 1,358
Views: 232,822
Posted By kiosk

RE: GAS Saito

man i dont know about that.....closing the throttle on mine chokes it just fine, starts in a few flips after. I have even done this with engine on bench and seen the fuel draw from tank as I flip the...
Forum: RC Warbirds and Warplanes
09-01-2009, 10:23 AM
Replies: 2,861
Views: 381,215
Posted By kiosk

RE: New Hangar 9 1.50 P-51 Build

hi edward, the issue if you use a program mix you cant access sub-trim function for that channel, if you look at my setup (pics posted above) you can use all channels w/o any program mix.....
Forum: RC Warbirds and Warplanes
09-01-2009, 07:42 AM
Replies: 2,861
Views: 381,215
Posted By kiosk

RE: New Hangar 9 1.50 P-51 Build

here is what mine setup is like...no need for matchbox or y-harness(stay away from y-harness, those things are lethal!!!!!)

the problem is Aux 4 & Aux 5 are sent at a different rate to the other...
Forum: RC Warbirds and Warplanes
09-01-2009, 07:18 AM
Replies: 2,861
Views: 381,215
Posted By kiosk

RE: New Hangar 9 1.50 P-51 Build

i use a 12 oz tank, and I can get 20+ min flites, thats one great thing about the FG36...extremely efficient!
Forum: RC Warbirds and Warplanes
08-26-2009, 11:02 AM
Replies: 2,861
Views: 381,215
Posted By kiosk

RE: New Hangar 9 1.50 P-51 Build

i dont think you will be happy with the gap if you dont use stock spinner, is over 1/4'', take a look at picture mine when I first built it using spinner with lip



initially I did use 30min...
Forum: RC Warbirds and Warplanes
08-26-2009, 03:44 AM
Replies: 2,861
Views: 381,215
Posted By kiosk

RE: New Hangar 9 1.50 P-51 Build

joejoe thats the trickiest part...BEFORE you drill any holes make sure everything lines up specially the spinner to fuse alignment and clearance.
this is what i did...

1. bolt the engine to...
Forum: RC Warbirds and Warplanes
08-20-2009, 02:30 PM
Replies: 2,861
Views: 381,215
Posted By kiosk

RE: New Hangar 9 1.50 P-51 Build

interesting day for frankie, after much 3D and IMAC flyin I decided to take the warbird out....on the last flite out of 5....dam gear stuck in up position, take a look at video.
sorry my spotter...
Forum: RC Warbirds and Warplanes
07-22-2009, 01:11 PM
Replies: 2,861
Views: 381,215
Posted By kiosk

RE: New Hangar 9 1.50 P-51 Build

i could understand the afford part but not the "want to" part, i can do pretty much a 2C gasser can but with the 4-stroke roar of the FG36 and 6FT from the deck "inverted" ;-)

just teasin u a...
Forum: Twin & Multi Engine RC Aircraft
07-16-2009, 06:56 AM
Replies: 1,122
Views: 193,021
Posted By kiosk

RE: Seagull's

i use the TWIN E function on my JR 9303 and is really nice, a must have I think for any twin...however I havent been able to use the trainer button to kill (close trim) on both engines (rather than...
Showing results 1 to 25 of 362
 
Page 1 of 15
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.