RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: Sarah
Showing results 1 to 25 of 168
Search took 0.70 seconds.
04-19-2011, 03:22 PM
Replies: 562
Views: 147,189
Posted By Sarah

RE: New Sebart Wind 50E

Hi Guys,

I've been flying my Angel 50 for quite some time now and it is my favourite aircraft to fly, with a Hacker A50-16S, Hacker X70 esc and 6S-3700 FLightpower Li-Po's.

I want to get...
Forum: RC Tanks
11-12-2009, 11:12 AM
Replies: 8
Views: 5,496
Posted By Sarah

RE: Armortek Panzer III 1/6 Model

Hi,

I've seen the Panzer III, very cool! Have a look at the Panzer III Forum on the Armortek website for more information and pictures.

As Rivetcounter states the Panzer III's are sold...
Forum: War Room
10-16-2009, 01:35 PM
Replies: 8
Views: 3,644
Posted By Sarah

RE: rctankwarfare forum

Hi Guys,

I hope it comes back as it's a great tank site.


Sarah
04-05-2009, 03:54 PM
Replies: 10
Views: 921
Posted By Sarah

RE: 5% or 10%

Hi Matador,

Whereas in the USA higher percentages of Nitro are used, in England the tendency is to use lower nitro fuels.

I've run the OS25FX's on 5% and they have run very well indeed. I...
01-01-2009, 05:08 PM
Replies: 664
Views: 134,064
Posted By Sarah

RE: Angel S EVO Build Thread

Hi Dale,

I set my timer for 10 minutes, though I have a lot left in the cells. I think I need to put around 2300 - 2700 MAHr after a flight.

With any new plane I set the timer quite low,...
12-31-2008, 03:38 AM
Replies: 664
Views: 134,064
Posted By Sarah

RE: Angel S EVO Build Thread

Hi Dale,

I have the standard Hacker motor set-up and I use the Flight Power EVO 25 3700 cells and also some Thunder Power 6s-5000, which are quite a bit heavier. I do find for pattern flying...
09-10-2008, 02:47 AM
Replies: 147
Views: 24,489
Posted By Sarah

RE: BLADE 400 questions

Hi Lucas,

There is a set up sheet for the newcomer to the Blade 400 at:

www.brcmac.org.uk

Look under the 'Heli Stuff' button for the 'Blade 400 Setup' sheet.


Regards,
07-11-2008, 03:14 AM
Replies: 664
Views: 134,064
Posted By Sarah

RE: Angel S EVO Build Thread

Hi,

I've got the standard Hacker motor in my Angel and she flies great, very impressed. I take off on just over half throttle, then go vertical rolling as I go up. It is 3D capable with that...
05-10-2008, 11:38 AM
Replies: 664
Views: 134,064
Posted By Sarah

RE: Angel S EVO Build Thread

Hi Guys,

I've finished my Angel and did the maiden flight today, very impressive! I've got the standard A50-16S setup with an 16x10 APC, the climb is so good.

One little problem is that...
05-04-2008, 02:30 AM
Replies: 6
Views: 1,229
Posted By Sarah

RE: FW190 aleron hindges -how visable

Hi LDM,

Another site for photographs of the FW190 is our club website:

www.brcmac.org.uk

On the left hand side click on 'Scale Data' then 'Warbirds' then click on the image of the...
04-17-2008, 05:03 PM
Replies: 4
Views: 1,159
Posted By Sarah

RE: Trouble With New OS .46AX

Hi Bax,

I hope you don't mind me replying to JC, as I thought it might be useful to him.



Hi JC,

My 46AX always ran with a red coloured oily residue as it was running a little on...
04-14-2008, 03:24 AM
Replies: 7
Views: 1,818
Posted By Sarah

Showtime 50 - Engine choice

Hi Mike,

After reading many threads I would be very grateful for your advice please.

I am about to purchase a Showtime 50 and I am a little unsure about what engine would be best.

I...
02-05-2008, 03:59 AM
Replies: 60
Views: 13,039
Posted By Sarah

RE: Fuel tanks for Hobbico Twinstar

Hi Bassomatic,

I see you have a plane next to your name now.

The Twinstar is finished, the engines have been in to set the linkages but are waiting to be run-in.
02-05-2008, 03:13 AM
Replies: 13
Views: 1,326
Posted By Sarah

RE: TF FW190 Engine choice?

Have you thought about electric. I'm working on mine now and I'm fitting a Hacker A50-12L with Thunder power 6S 5000 Li-Po. I used this setup in my H9 Mustang with an APC 15x8e prop and it was so...
02-04-2008, 07:16 AM
Replies: 2,995
Views: 524,485
Posted By Sarah

RE: KMP / YT FW-190 Build Thread

The instructions don't mention any side thrust, or down thrust. How much side thrust are you guys using?

Many thanks
01-23-2008, 05:06 PM
Replies: 60
Views: 13,039
Posted By Sarah

RE: Fuel tanks for Hobbico Twinstar

Hi Bassomatic,

The first tank I reshaped did not turn out very well, when I heated it and applied pressure it just crumpled in the middle.

On the next two I sealed the tank with the...
01-23-2008, 11:45 AM
Replies: 60
Views: 13,039
Posted By Sarah

RE: Fuel tanks for Hobbico Twinstar

Hi Guys,

Here are some photo's of the 6oz tanks in my Twinstar. They are Sullivan 6 oz FRST-6 Rectangular Flextanks, which have been carefully reshaped with a hairdryer. The tanks fill the bay...
01-21-2008, 05:01 AM
Replies: 24
Views: 3,878
Posted By Sarah

RE: Blade 400: Power Cuts Out to Motor

I've had a similiar problem with aircraft and the ESC was set to the wrong number of Li-Po cells. When it was set to the correct number of cells the problem went away.

Has anyone any idea how...
01-19-2008, 08:11 AM
Replies: 2,995
Views: 524,485
Posted By Sarah

RE: KMP / YT FW-190 Build Thread

Hi Bladerunner,

Your FW190 does look good in flight. I'm getting tempted to power mine with a brushless. I've tried to get the specs on your motor, but I can't find a KMS 53 low count. Could...
01-16-2008, 05:42 PM
Replies: 60
Views: 13,039
Posted By Sarah

RE: Fuel tanks for Hobbico Twinstar

Hi Baasomatic,

I've been busy, but I have been spending time on it this week. I hope to run the engines at the weekend then refit them and then it will be ready for it's maiden flight.

I...
01-16-2008, 01:42 PM
Replies: 60
Views: 13,039
Posted By Sarah

RE: Fuel tanks for Hobbico Twinstar

Hi Bassomatic,

The tanks are positioned over the CofG so they won't affect the CofG at all, whether they are full or empty.

Sarah
01-07-2008, 10:10 AM
Replies: 147
Views: 24,489
Posted By Sarah

RE: BLADE 400 questions

As the motor is basically a three phase motor it would be best to disconnect all three wires.


Sarah
01-05-2008, 02:45 AM
Replies: 147
Views: 24,489
Posted By Sarah

RE: BLADE 400 questions

I think you may have some servo's still reversed, as when the left hand stick is raised the swashplate should go down. Might be worth checking everything against the Blade book, pg 17 onwards to...
12-28-2007, 08:52 AM
Replies: 106
Views: 10,100
Posted By Sarah

RE: New 400 Eflite update Anyone?

Hi Peter,

After checking the actual pitch range of both Blade 400's we discovered that the factory Normal and Stunt pitch ranges were all 4 degrees high at every point. This probably explains...
12-26-2007, 02:20 AM
Replies: 106
Views: 10,100
Posted By Sarah

RE: New 400 Eflite update Anyone?

Hi Peter,

We ended up at 50% +ve expo on cyclic (elev, aile) & rudder. Later when he is flying better we may start to reduce it, but then again I know some very capable flyers who fly with upto...
Showing results 1 to 25 of 168
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.