RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: sengli
Showing results 1 to 25 of 61
Search took 0.66 seconds.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
12-23-2022, 01:13 PM
Replies: 3
Views: 680
Posted By sengli

On your transmitter, go into the programming menu...

On your transmitter, go into the programming menu and reverse that channel. What transmitter model do you have? Reversing the channel just gets the ESC to work with the futaba RX. This does NOT...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
12-23-2022, 12:46 PM
Replies: 26
Views: 33,849
Posted By sengli

I also bought the 14SG because it will do all of...

I also bought the 14SG because it will do all of the protocols. I only have ever used the FAST. I never tried the orange RXs, but since you could get the futaba R6017s for around $60 I went that...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
12-23-2022, 12:36 PM
Replies: 11
Views: 1,165
Posted By sengli

Good to know about this. Like you I have never...

Good to know about this. Like you I have never used the S-bus connections. I just dont need it for my simple models.

On a side note, I find the programming on the 14SG to be way cumbersome as...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
12-23-2022, 12:19 PM
Replies: 5
Views: 1,021
Posted By sengli

I have a TM7, TM10, and a TM14 in my futaba TXs. ...

I have a TM7, TM10, and a TM14 in my futaba TXs. They have so far been great.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
12-23-2022, 12:17 PM
Replies: 3
Views: 1,418
Posted By sengli

check with maxxpacks.com....they sell NIMH packs...

check with maxxpacks.com....they sell NIMH packs that are direct replacements for your old nicads.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
12-23-2022, 12:15 PM
Replies: 9
Views: 974
Posted By sengli

I have 3 of system still I dont fly anymore in...

I have 3 of system still I dont fly anymore in the box, I think they are channel 29
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
12-23-2022, 12:11 PM
Replies: 18
Views: 3,544
Posted By sengli

I ended up getting the NIMH packs rated at...

I ended up getting the NIMH packs rated at 2200mah from maxxpacks. They fit in the same space in the TX, and I can use my hobbico charger set for the higher charge rate of 125mah. This ought to last...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
12-23-2022, 12:06 PM
Replies: 19
Views: 4,183
Posted By sengli

I am old school and only fly futaba systems. The...

I am old school and only fly futaba systems. The newest one I have is a 12Z. Since tower hobbies went under, its hard to find futaba gear easily.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
12-23-2022, 12:03 PM
Replies: 3
Views: 680
Posted By sengli

Yes it will work with futaba Rxs. I find I have...

Yes it will work with futaba Rxs. I find I have to reverse the throttle channel to work. I have several dracos, and many other eflite planes that I only use futaba systems in.
Forum: Beginners
12-23-2022, 11:53 AM
Replies: 1
Views: 671
Posted By sengli

I have two Dracos, and I also only fly futaba...

I have two Dracos, and I also only fly futaba systems. I ended up removing the AR637 spectrum RXs and selling them. I didnt see any way to hook up the reverse, but I didnt really want to spend too...
Forum: Marketplace
11-16-2022, 05:51 AM
Replies: 4
Views: 260
Posted By sengli

would you take $325 including shipping via USPS...

would you take $325 including shipping via USPS to zip code 46750?
Forum: Marketplace
11-16-2022, 05:15 AM
Replies: 4
Views: 260
Posted By sengli

Brock is this system one that you were...

Brock

is this system one that you were flying? Is everything is working order? Did it come with a manual?

Steven
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
10-30-2022, 01:36 PM
Replies: 18
Views: 3,544
Posted By sengli

Futaba TX batteries?

I have an older 9C, and 10C transmtters that I still fly. Is there a better replacement battery system, other than the old school nicads? Can you run a 3 cell lipo, or LIFE as a battery source...
Forum: Marketplace
09-10-2020, 06:45 AM
Replies: 1
Views: 431
Posted By sengli

New spectrum receiver

I have a new, never flown spectrum 636 sport receiver. Has the link plug, and a lead to connect it. Free shipping to the lower 48 only, via USPS
Forum: ARF or RTF
12-23-2015, 01:17 PM
Replies: 4
Views: 875
Posted By sengli

I guess that is a thought. I wasnt sure there...

I guess that is a thought. I wasnt sure there was any aftermarket mufflers, but bison does apparently make one like you suggest for like $70.00. One of the key selling points on the OS is they...
Forum: ARF or RTF
12-23-2015, 12:05 PM
Replies: 4
Views: 875
Posted By sengli

Escapade 30, and a OS33

Just bought this combo airplane and engine recently. Finally started to assemble this plane, and the rear wrap around muffler doesnt even come close to clearing the firewall, as they suggest to in...
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
07-21-2013, 12:43 PM
Replies: 2
Views: 1,522
Posted By sengli

RE: raptor titan x50

Looks like the metal main blade grips are discontinued.
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
04-28-2013, 06:21 PM
Replies: 7
Views: 1,711
Posted By sengli

RE: Main Gear wearing

I recieved a replacement main gear from hobbico today, along with a note. The note states there were a certain number of the kits released that had soft main gears, so they wore pre-maturely. I...
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
04-22-2013, 11:03 AM
Replies: 7
Views: 1,711
Posted By sengli

RE: Main Gear wearing

When I assembled it, the bearings on the shaft/ starter seemed like they fit snugly enough. And obviously they fit into the recessed areas in the frame O.K. Thats why this is so out of the ordinary...
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
04-22-2013, 10:02 AM
Replies: 7
Views: 1,711
Posted By sengli

RE: Main Gear wearing

No, I built it from a kit with the supplied parts. Just to make sure I counted teeth. Its a 10 tooth pinion, and a 85 tooth main gear. Although the blade holders from this kit were not the correct...
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
04-22-2013, 05:34 AM
Replies: 7
Views: 1,711
Posted By sengli

Main Gear wearing

I have had raptors for years. My old V1 never did this. I have a brand new titan, all stock and the pinion on the clutch bell, is wearing the main plastic gear. There is alot of white plastic dust...
Forum: RC Gliders, Sailplanes and Slope Soaring
02-21-2011, 01:34 PM
Replies: 2
Views: 3,477
Posted By sengli

RE: Radian Pro balance issue

I was very dissappointed with horizons answer when I called thier customer service people to explain what my issue is with this CG issue. If you watch thier video on this new radian pro, they do say...
Forum: RC Gliders, Sailplanes and Slope Soaring
02-14-2011, 07:05 AM
Replies: 67
Views: 29,503
Posted By sengli

RE: Radian Pro - A new e-glider from Parkzone

I have a PNP version. It flies O.K. The wings and the tail flexes alot in windy conditions so it flies wishy washy. At least compared to my balsa built gliders, but its O.K. The power system in...
Forum: RC Gliders, Sailplanes and Slope Soaring
02-14-2011, 06:52 AM
Replies: 2
Views: 3,477
Posted By sengli

Radian Pro balance issue

Just want to warn any other people on this issue. Bought a radian pro PNP version and assembled it per the instructions. Keep in mind there are molded spaces where your components are supposed to...
Forum: RC Gliders, Sailplanes and Slope Soaring
02-14-2011, 06:36 AM
Replies: 19
Views: 4,484
Posted By sengli

RE: Radian pro

I have one of these radian pro's and mine for some reason was either molded heavy or something odd. Mine was the PNP version and was terribly tail heavy if you assembled it per the intructions. I...
Showing results 1 to 25 of 61
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.