Mamba Programming Problem
12-31-2007 | 09:28 AM
#1
Thread Starter
Senior Member
Joined: Aug 2007
Posts: 153
Likes: 0
Received 0 Likes
on
0 Posts
From: Kannapolis,
NC
Mamba Programming Problem
I just installed a Comp Kit in my Mini LST. Heres the problem. When I go into the programming mode it may let me set the first 2 settings then it just ends programming itself. It won't let me go thru the programming setup without stopping on it's own. Any Ideas?
12-31-2007 | 09:51 AM
#2
Senior Member
Joined: Jul 2006
Posts: 2,633
Likes: 0
Received 0 Likes
on
0 Posts
From: Genoa,
IL
RE: Mamba Programming Problem
Sounds like you are not in "programing" mode and its just calibrating too the controller .
When you turn on the ESC , hold the throttle down till it beeps and continue to hold the throttle down till it enters programing mode , it should start to beep slowly (beep, long pause then another beep) you should be at the first program option then .
When you turn on the ESC , hold the throttle down till it beeps and continue to hold the throttle down till it enters programing mode , it should start to beep slowly (beep, long pause then another beep) you should be at the first program option then .
12-31-2007 | 10:02 AM
#3
Thread Starter
Senior Member
Joined: Aug 2007
Posts: 153
Likes: 0
Received 0 Likes
on
0 Posts
From: Kannapolis,
NC
RE: Mamba Programming Problem
It goes into the programming mode. I hit full brake to answer no and may get through the first setting then it just exits on it's own.
