RCU Forums - View Single Post - Is that OK ? (Turbine to pipe gap)
Thread: Is that OK ? (Turbine to pipe gap)
View Single Post
Old 11-21-2010 | 03:01 PM
  #19  
digitech
My Feedback: (10)
 
Joined: Aug 2004
Posts: 3,654
Received 10 Likes on 10 Posts
Default RE: Is that OK ? (Turbine to pipe gap)
ORIGINAL: eskiserkan

Hi Guys

I got the ''Bell Mouth'' from Andy (thanks a lot again) and installed it into my pipe.

But the distance has decreased nearly by one cm between end of the exhaust nozzle and entrance of the bell mouth. Now the measured actual distance is 1.65 cm as you can see in the photo.

My question is : Will it work like that ?

I will be glad if you can let me know.


here is the first drawing : http://www.jetcat.de/downloads/p80drawun.pdf
and this picture , a good source to have even if you dont read german
digitech is offline  
Reply Like