Currently I am working on two P20 powered projects and required pipes for the installations, there are a few pipes about on the market but one was too short and a little heavy, and one was very expensive!
As we (Richard Chant) and myself will be launching a new composite P20 powered jet shortly it made sense to look to make some pipes for this application.
The trickiest part is the intake bell-mouth, so following a few discussions and exchange of drawings with a metal spinning company a box full of gleaming bell-mouths arrived a short while ago. I hope the stainless pipes will be here tomorrow so I can make up the finished article.
I over ordered so if anyone out there wants a pipe for the P20 just PM me for more info.

marcs