RCU Forums - View Single Post - DON MUDDIMAN FLYING MACHINE SHORT KIT BUILD
Thread: DON MUDDIMAN FLYING MACHINE SHORT KIT BUILD
View Single Post
Old 02-06-2011 | 08:36 AM
  #39  
Nitro-Tom's Avatar
Nitro-Tom
Senior Member
 
Joined: Jul 2007
Posts: 586
Likes: 0
Received 0 Likes on 0 Posts
From: South Florida, FL
Default RE: DON MUDDIMAN FLYING MACHINE SHORT KIT BUILD
ORIGINAL: flyingmachine

anyone on here please share your throw settings and expos for elvator and aileron

thx rich

ok, mine is setup as follows: (Dx7 Tx and AR7000 Rx) 6 V 2000Mah

Low Rates:

Rudder-1/2" 25% Expo
Elevator-1/2" 35% Expo
Aileron-3/8" 35% Expo

High Rates:

Rudder-7/8" 50% Expo
Elevator-7/8" 70% Expo
Aileron-3/4" 70% Expo



mine is a little more than the recommended 3/8" low rates for elevator and a little less on rudder....I could only get 7/8 out of the rudder, and did not need more for knife edge....

Nitro-Tom is offline  
Reply Like