RCU Forums - View Single Post - PROGRAMING DIGITAL SERVOS
Thread: PROGRAMING DIGITAL SERVOS
View Single Post
Old 02-26-2011, 09:52 PM
  #1  
Mrs R
Member
 
Join Date: Jan 2011
Location: Tamworth, AUSTRALIA
Posts: 41
Likes: 0
Received 0 Likes on 0 Posts
Default PROGRAMING DIGITAL SERVOS
Hi!
I have been setting up the rudder and elevator servos with my DSX9 TX 1 channel per servo average 55 deg. Centre to end point. with the HPP-21 45 Deg. from centre point only.

Is it possible to set the centre point mechanically by adjusting the servos gears. or is the output shaft connected directly to the Pot.

Rachael
Mrs R is offline  
Reply Like