PROGRAMING DIGITAL SERVOS
02-26-2011 | 09:52 PM
#1
Thread Starter
Member
Joined: Jan 2011
Posts: 41
Likes: 0
Received 0 Likes
on
0 Posts
From: Tamworth, AUSTRALIA
PROGRAMING DIGITAL SERVOS
Hi!
I have been setting up the rudder and elevator servos with my DSX9 TX 1 channel per servo average 55 deg. Centre to end point. with the HPP-21 45 Deg. from centre point only.
Is it possible to set the centre point mechanically by adjusting the servos gears. or is the output shaft connected directly to the Pot.
Rachael
I have been setting up the rudder and elevator servos with my DSX9 TX 1 channel per servo average 55 deg. Centre to end point. with the HPP-21 45 Deg. from centre point only.
Is it possible to set the centre point mechanically by adjusting the servos gears. or is the output shaft connected directly to the Pot.
Rachael
