RCU Forums - View Single Post - Problem programming servo.
Thread: Problem programming servo.
View Single Post
Old 08-12-2003 | 10:26 AM
  #2  
Crash90
Senior Member
My Feedback: (17)
 
Joined: Oct 2002
Posts: 2,320
Likes: 0
Received 0 Likes on 0 Posts
From: Cressona, PA
Default Problem programming servo.
Woke up this morning and tried it again. It worked for a few minutes. I reset factory settings, set center point and left end point then it stopped working again. ??
Crash90 is offline  
Reply Like