Problem programming servo.
08-12-2003 | 01:25 AM
#1
Thread Starter
Senior Member
My Feedback: (17)
Joined: Oct 2002
Posts: 2,320
Likes: 0
Received 0 Likes
on
0 Posts
From: Cressona, PA
Problem programming servo.
I have 2 new 5925 servos which I am trying to program center and endpoints. The first one went fine. The second one doesn't seem to be working. I try to reset factory settings and the programmer says searching but then it blinks once and goes back to the reset screen. When I try to set center and endpoints the same thing happens. I get no response from the servo when it is plugged into the receiver except for the fact that I cant move the servo arm when the switch is turned on. The servo worked fine last night when I was programming it. Can you help?
I just bought the servo friday.
Also If I need to send it in, I can't find the receipt. My LHS can verify purchase date or give me a photo copy of his sales slip.
I just bought the servo friday.
Also If I need to send it in, I can't find the receipt. My LHS can verify purchase date or give me a photo copy of his sales slip.
08-12-2003 | 10:26 AM
#2
Thread Starter
Senior Member
My Feedback: (17)
Joined: Oct 2002
Posts: 2,320
Likes: 0
Received 0 Likes
on
0 Posts
From: Cressona, PA
Problem programming servo.
Woke up this morning and tried it again. It worked for a few minutes. I reset factory settings, set center point and left end point then it stopped working again. ??
08-12-2003 | 04:00 PM
#3
Senior Member
My Feedback: (1)
Joined: Jan 2002
Posts: 3,531
Likes: 0
Received 0 Likes
on
0 Posts
From: Poway, CA
Problem programming servo.
Hmmm... I would contact our service manager tony @ [email protected] and he'll figure out the best way to help you.
Mike.
Mike.
