Hi,

Iron Eagle mentioned a good discussion about boost tabs and trim tabs in this section of the site, well i'm looking to add either one of these types on the rudders and elevators on my Constellation model.

http://www.rcuniverse.com/forum/m_45...page_40/tm.htm
Go to bottom on this link to see posts regarding it.

My reason is same as few have mentioned in this thread already, i want to use 3 mini MG servos, 1 on each rudder on this model, now problem is that i can't find a servos in this size that will do the job w/out addition of tabs, so what do u guys suggest.
Out board rudders surface area is equivalent to LT-40 rudder and center one is less....