Hi rotor heads With the help of an expert I got my EXI 450 flying and have done a little solo hovering. Somehow I deleted or replaced the programming for it in my Dx6i and I can't seem to get things right again. I've watched a half dozen Youtube videos on programming and read the manual. I even started with a new model name and programmed it all over. No matter what I've tried the L and R aileron controls seem to work together and move the head up and down as if it were a pitch change. It seems like the mixing is screwed up and I don't know where to go now. Any ideas what I may be doing wrong. I followed all directions. One additional fact that may or may not be relevant. I'm using an orange clone receiver that binds properly but sometimes blinks slowly about half battery from getting low. Is this a problem or related?
Thanks
Ron