<div id="post_message_19153547">I have a brand new PNP Habu that I was setting up with my Hitec Aurora 9 radio. I havent flown the plane yet but I had everything working. I have a Castle Creations BEC 10 Amp installed for the reciever power. I cut the red wire from from the ESC for power going to the receiver like you are supposed to do. Right out of the blue the throttle quit working. I installed a spare fan/motor and still didnt work. Swapped out the servo wires with no help. I am at a loss. Only thing I can think is that the ESC went bad. I didnt let the smoke out lol. But just suddenly stopped working. I did check my channel 3 on my radio to make sure it wasnt radio or receiver and that all checked out fine. Any help would be greatly appreciated. Thanks, Phil</div>