meebo in regards to the two servos on the ailerons. Its more precise. It also allows you to fine tune them alot better. You can also set up flaps on them. Its just a whole lot better IMO. I have a servo on each aileron on both my hyperion snyper and my extra 260 and i love it. You can really dial them in. If you have one aileron you have to be very precise in making the control rods that go out to the control horns. If your a little bit out then its going to throw the whole plane out of wack. This was the case with my original 3d hawk. But i just adjusted my flying style to suit.

Anyways also have a look at this bad boy ok. Yes its expensive but its so worth it.

[youtube]http://www.youtube.com/watch?v=WQF5mRSAQ4Q[/youtube]

Although Michael makes it look effortless this little plane is very capable of some serious 3d flying.

Anyways i had a great morning with my dad. His rc boat is performing so well now. I just have to get my boat going as good as his now. We have ordered alot more parts so my boat will be running the same parts as his. We are going to put a 100a esc turnigy DX esc in mine and try a 4s lipo in it. We want to see hard we can push these boats. We will leave dads as is and use mine to experiment with. We have so many spares on the way now so we should be set if we have any problems. We sealed dads boat with electrical tape and he had no more then a thimble of water in it now. We are both so happy that after all this time we have finally ironed out all the kinks and got it going really well. Dads really not worried about the money we have spent on them so far. He loves mucking around with them with me. Hes now talking about making a jump and some bouys so when we race it will make it more interesting.

Anyways boys we might have to hit up pheonix laters if you are around.

Time for a quiet beer or two i think.