RE: Hangar 9 Beast
Here are just a bunch of random photos of how I have things setup. A couple of highlights I will point out, I did go with springs on my tail wheel. I have my smoke oil tank on the top (which is 32 oz.) and my gas tank on the bottom (which is also 32oz.) Off to the side of the tanks is my smoke pump and battery. It is a really tight fit when you go and try to strap things down in there. One thing you may or may not be able to notice is that on my rear cabane struts, I have my servo extension cables running up (on the inside) to the top center section wing and they stick out the holes at the top. You cant see the servo wire because I took a peice of black shrink tubing and slid it over the cabane strut and ran the extension through the shrink tubing and then I shrunk it tight. It sort of hides the ugly wires going up to the top wing. When I installed my throtle linkage, I had that same little bend in the push rod tubing as well (as seen in one of the photos). If you have a question on someting else you see in one of the photos you can just ask me.
David