ORIGINAL: Hemikiller
I'm going to venture into the HV realm on my next plane and will start off using the 5495BH servos, 2S Lipo and an Optima series receiver, either a 6 or 7.
What is the best way to wire this for a glow powered plane?
A) 7.4V directly to the BAT/servo port
B) 7.4V -> regulator to X voltage - > BAT port
C) Pull SPC jumper and go 7.4V ->Y -> SPC & BAT
D)or?
Thanks in advance!
I'm using A. 7.4V directly to BAT/servo port and SPC jumper still in place.