RCU Forums - View Single Post - Cowl material 3d hobby 540 edge
Thread: Cowl material 3d hobby 540 edge
View Single Post
Old 02-17-2012 | 01:24 PM
  #5  
zacharyR
My Feedback: (5)
 
Joined: Dec 2008
Posts: 650
Likes: 0
Received 0 Likes on 0 Posts
From: Tampa, FL
Default RE: Cowl material 3d hobby 540 edge

ORIGINAL: frenchie79

Anyone know what material the cowl on 3d hobbies model 540's are made of? Going to reinforce the cutouts for engine. I'm thinking Epoxy.

your on the wrong forum for this type of question you should chose the forum's where the 3DHS ppl hang out .... and that's not RCU



I dont see the need to reinforce the cut outs ?
zacharyR is offline  
Reply Like