RCU Forums - View Single Post - Balsa USA 1/4 Scale Nieuport 28 Build
Thread
:
Balsa USA 1/4 Scale Nieuport 28 Build
View Single Post
05-05-2012, 04:17 PM
#
121
SunDevilPilot
Join Date: May 2002
Location: Gilbert, AZ
Posts: 2,025
Likes: 0
Received 3 Likes on
3 Posts
RE: Balsa USA 1/4 Scale Nieuport 28 Build
Left panel got it's wing tip and upper spars... Just waiting for that to dry then I'll install the sub-leading edge. Sheeting will begin tomorrow.
I also installed a fence onto my bandsaw. The fence should allow me to rip down small strips of balsa. For sheeting I use the table saw but the bandsaw is great for thin strips.
SunDevilPilot
Attached Thumbnails
Reply
Like
SunDevilPilot
View Public Profile
Send a private message to SunDevilPilot
Find More Posts by SunDevilPilot
View iTrader Profile