RCU Forums - View Single Post - Echo 16cc conversion results
Thread: Echo 16cc conversion results
View Single Post
Old 05-31-2012 | 10:17 PM
  #4  
av8tor1977's Avatar
av8tor1977
My Feedback: (6)
 
Joined: May 2003
Posts: 7,245
Likes: 0
Received 6 Likes on 5 Posts
From: Tucson, AZ
Default RE: Echo 16cc conversion results
The one I had was ball bearing. I don't think Echo used any roller crank bearings. (If they did, it was probably on an older chain saw, though I doubt it even then.) I am quite positive they never used a bushed bearing rod...

AV8TOR
av8tor1977 is offline  
Reply Like