Hi guys,
I'm in some serious trouble...
I'm replacing air cyl in ESM retract, but there's no diagram or pic in the instruction manual... just WORDS and I am a little dyslectic (really) [
]
1) there is one cylinder-pin in the original setup. There are 2 cylinders on the new actuator (?) one is for a diferent retract setup or what? It doesn't say anything about this in the instructions
2) in the instructions, it says something about installing the "cyl/ pin" in the middle of the threaded rod, WHY? when open, it should be on one end & and when closed it should be on the other end, right?
Can anyone who has done that help me please? A picture is 1000 words, pic of the finished install would be a BIG help.
I'm sweating bullets
Thanks in advance for any help,
V.