RE: Hunter Twin Build
Afternoon guys. Ok, so here's where I'm at. Going to order another head and end up reversing one of the heads on the twin. Just going to be cleaner, look better, balance better and just be good all around. So that's this weekend.
My question is this. Mostly for Matt on this one too since I'm taking his advice. I'm opting not to run the servo adjusted trims initially. I'll keep the hardware and servos in case I want to later. So my question is approx drive angle. More up? More down? And this goes right into my next question.
Balance. I know it was supposed to be like 34% length from the transom or something similar.....I have it marked on the hull now. And I have almost everything in there but the radio box. I figure I'll use that to fine tune things. And it shouldn't be overly heavy I don't think anyway.....and if anything I would think I would want the boat more butt heavy than nose heavy correct?
Mike