RCU Forums - View Single Post - Hitec 5645MG continue to move?
Thread: Hitec 5645MG continue to move?
View Single Post
Old 05-15-2013, 09:20 AM
  #2  
BuschBarber
My Feedback: (2)
 
Join Date: Jan 2002
Location: Rochester, NY
Posts: 4,760
Likes: 0
Received 2 Likes on 2 Posts
Default RE: Hitec 5645MG continue to move?

ORIGINAL: stevehookem

I just purchased a 30cc plane that is brand new, ready to fly and features Hitec 5645MG servos on all surfaces. It came with a Futaba receiver and I pulled that since I fly JR. It's all running through a Smart Fly Sport with two Fromeco 7.4 batteries.

Question: after hooking everything up to my receiver, the servos continue to move slightly after I have hit the stick to the far limits. If it was just one doing this, I'd think it was bad. However, several do this. Any thoughts on what this may be? Is it safe to fly?
I would look at the settings on the Smart Fly Sport with regard to voltage. Servo extensions are another source for this kind of servo behavior.
BuschBarber is offline  
Reply Like