RE: BJCraft BISIDE
I'll post all of the weights along with more pics. It might not be till later next week since I have to travel for the next several days. Bummer, since I am anxious to get going on this.
I flew the prototype with the flying stab. Since I only had a few flights it is a bit hard to say definitively but my impression was that it gave a more consistent feel when doing loops and loop segments. It had a very linear feel to it. By this I mean that it felt like I was doing much less elevator control variation throughout a loop than with a standard elevator.
I'm checking on servo setups for the Bi Side right now and trying to decide which elevator servo setup to use. I am also trying to decide which way to go on ailerons (two servos or four). I'll get all that narrowed down and then start the heavy lifting on the construction when I get back.