RCU Forums - View Single Post - Help with offset mix for gear
Thread: Help with offset mix for gear
View Single Post
Old 07-26-2013 | 06:38 AM
  #9  
bcovish's Avatar
bcovish
My Feedback: (8)
 
Joined: Feb 2002
Posts: 5,324
Likes: 0
Received 1 Like on 1 Post
From: Austin, TX
Default RE: Help with offset mix for gear

ORIGINAL: kirkj

i would like to ask again..... you have doors and retracts running off the same single BVM valve? no other valving?
I with Kirk on this one. The OP is using ONE servo and ONE valve.
bcovish is offline  
Reply Like