I bought one of these new from an aftermarket supplier. It's going on a 1/3 Waco YMF currently being built. This is my first big gas engine beyond a G-62, and I know next to nothing about it. The rear mounted carb was kinda unhandy when coming up with an engine mounting scheme. Others convinced me the long standoffs I had were a gamble. So I made a wood box for a mount. Now the carb is inside the box. I made a throttle servo linkage, but ignored the choke up to now. I just reviewed the instructions for electronic module and saw it has an automatic choke. Another mounting headache to run a servo to choke arm. Is this choke good and needed? If so, I would welcome any installation info, ideas, or photos if anyone has one of these engines mounted on / in a box.

Thanks,

mike Hopkins