Dennis, are you reading the same thread I am? Take a look at post #3. I only gave the information the OP needed. It wasn't until you came around and started talking about about a product that the OP clearly did not have. He asked if he should follow the instructions that state the cure should be done at or above 70 degrees. We told him yes. It wasn't until you came around much later that this became an issue. If you think what we have said to this point as being overcomplicated then you have no real clue about composites as we really have kept it simple to this point. It's obvious that you feel you have nothing to learn and I really can't care less about this but seriously stop being the class clown here. Rodney has already stated that he feels our information has value and that is good enough for me to continue to answer composites related questions to the best of my ability. If you don't like that may I suggest the door once again.