RCU Forums - View Single Post - BUSA 1/3 Scale Ercoupe Build
View Single Post
Old 12-20-2014 | 12:49 PM
  #30  
Pete S-RCU
 
Joined: Dec 2001
Posts: 694
Likes: 0
Received 0 Likes on 0 Posts
From: Prior Lake, MN
Default

I'm installing the wing center section on mine now, what's the wing incidence supposed to be?
How about stab incidence?
Don't find any reference to it anywhere.,
How about right thrust, it says 1 1/2Degres down thrust, but no right thrust reference on the plans, but I found in the manual 1 degree down and 1 right?
I'll call BUSA on Mon.

I'm using the Saito FG57 twin engine, going to be a challenge getting it in.
The carb is on the rear and will be inside the mounting box.
Hard to hook up throttle linkage, fuel lines etc, also the tank is supposed to be inside the box.
It's too big and there's no room with carb in there.

Thanks,

Last edited by Pete S-RCU; 12-21-2014 at 09:55 AM.