RCU Forums - View Single Post - Another Full flying pivot location thread
Thread
:
Another Full flying pivot location thread
View Single Post
03-13-2015 | 02:42 PM
#
2
All Day Dan
My Feedback: (
5
)
Joined:
Dec 2002
Posts:
4,606
Likes: 1
Received 3 Likes on
3 Posts
From:
MANHATTAN BEACH, CA
Brian, you can do the calculation by the area rule. Locate the CG where 25% of the wing area is in front of it. I used AutoCAD to do this for a Benny Howard Pete I designed. It flew fine at the calculated area and no changes were required. Dan.
Attached Thumbnails
Reply
Like
All Day Dan
View Public Profile
Send a private message to All Day Dan
Find More Posts by All Day Dan
View iTrader Profile
