All slats from the end of the root part are treated level, except for the lower side member, it is processed later.

[ATTACH]2211727[/IMG]

[ATTACH]2211728[/IMG]

[ATTACH]2211729[/IMG]

On the lower rails glued plywood corners.

[ATTACH]2211731[/IMG]

[ATTACH]2211733[/IMG]

On the top slats are also glued corners.

[ATTACH]2211737[/IMG]

[ATTACH]2211739[/IMG]

[ATTACH]2211741[/IMG]

The lower spar is cut to size before the end and one end is bent at an angle.

[ATTACH]2211743[/IMG]

[ATTACH]2211745[/IMG]

[ATTACH]2211747[/IMG]

[ATTACH]2211749[/IMG]

[ATTACH]2211751[/IMG]

Edge for the endings.

[ATTACH]2211753[/IMG]

[ATTACH]2211755[/IMG]

[ATTACH]2211757[/IMG]

[ATTACH]2211759[/IMG]

Lower rails, from the corners to the edge for the endings.

[ATTACH]2211761[/IMG]

[ATTACH]2211763[/IMG]

[ATTACH]2211765[/IMG]

[ATTACH]2211767[/IMG]

Top slats, from corners to ribs.

[ATTACH]2211770[/IMG]

[ATTACH]2211771[/IMG]

[ATTACH]2211773[/IMG]

The lobic on the end is different from the forehead in the root part, it is marked with a small hole.

[ATTACH]2211776[/IMG]