I have recentley installed a bixler 2 on my transmitter. Using y harness, reversed one of the flap servos using gear channel and aux. 1 with switch B 2 way
switch. Up for takeoff, and down for flaps. However, I am still trying to figure out how to mix in a bit of elevator. Read the manual and been on the net
with very little explanation. DX6 is not too detailed in my opinion for me to figure it out. I understand basic programming of the DX6, but mixing makes
me a bit nervous for fear I will cancel out some of my other r/c planes by mistake. I am 80 years of age. However still determined how to figure things out.
Hoping I can get some expert instructions. This is my last hope. If not, I will just have to apply down elevator manually when using the flaps.
Thanks guys.
Louis Petrolia
[email protected]