RCU Forums - View Single Post - Need help making a silicon mold
Thread: Need help making a silicon mold
View Single Post
Old 04-13-2018 | 03:25 PM
  #7  
DAN AVILLA's Avatar
DAN AVILLA
My Feedback: (12)
 
Joined: Dec 2001
Posts: 834
Likes: 0
Received 27 Likes on 21 Posts
From: Prescott, AZ
Default
To all that responded thanks. At the time when Sid responded I all ready order the silicone. It cost me 100.00 to my door. I wish I knew about the great videos that were posted . I would have done it in glass. Im not sure the up front cost would have been cheeper but the supplies they used would have made a lot of molds in the future. The part came out good. The mistake I made was not doing my home work on the second silicone pour. It stuck to the original silicone mold. I had to cut it apart so the seam line was not as crisp. Good learning experience . Dan


DAN AVILLA is offline  
Reply Like