Chatty, the Jeti gang may want to comment but I have seen an issue with the REX receivers periodically disconnecting from telemetry (I see it with the CB200 and CB400 .. it goes from "checkmark" to "x" in device explorer for several seconds from time to time). I gather that a new firmware update is coming that may address this. Perhaps you have the same issue?

These servos look really interesting, I got two of them to evaluate and while they are VERY nice, I was disappointed that only the receivers support the servo telemetry at this time. Until the central boxes support them, they are not really much use .. for most of the installs where their telemetry would be useful, it's a large or complex airplane that would not use a RX without a CB.

Any outlook from the Jeti folks for when this functionality might be coming? CB400 only? New CB200 follow-on?

Dave