RCU Forums - View Single Post - BH Twister
Thread
:
BH Twister
View Single Post
01-21-2019, 04:47 PM
#
15
H5606
Join Date: Jul 2006
Location: TN
Posts: 924
Likes: 8
Received 41 Likes on
40 Posts
Starting with the addition of 1.5" to the top of the apex (former at the wing TE), a line connecting the apex to the existing tail block defines the top of the additions for the other formers. Accounting for skin thickness offset, cut these formers from scrap 1/8" lite-ply and removed mat'l from the centers.
Bonded these former extensions to the tops of the formers including one on the top of the over-wing hatch fairing to support sheeting at center point. Cut and installed 1/16" sheeting to aft fuselage top.
Debated about the area fwd of the apex, thinking about simplicity of straight line to remain "Hots-like" or introducing complexity with a curve. Decided to create curve with the intention of gaining even more area over wing and hopefully supporting knife-edge flight.
Last pic shows dry fit of fwd area sheeting with canopy-like curve to center section hatch to judge general outline.
Last edited by H5606; 01-21-2019 at
05:07 PM
.
Reply
Like
H5606
View Public Profile
Send a private message to H5606
Find More Posts by H5606
View iTrader Profile