RCU Forums - View Single Post - 1/4 Scale Pfalz DIIIa
Thread: 1/4 Scale Pfalz DIIIa
View Single Post
Old 03-25-2019, 08:49 AM
  #68  
mgnostic
 
mgnostic's Avatar
 
Join Date: Jan 2003
Location: Kamay, TX
Posts: 1,597
Received 86 Likes on 74 Posts
Default
Originally Posted by do335a
The right angle carb intake manifold from Toni Clark will give you much better clearance than the stock arrangement.
Have a look:
https://www.toni-clark.com/english/m...8/zg38zube.htm
Lot's of nifty stuff. I think if one were going for a competition level model it would work best to engineer the engine mounting box for a rear intake engine. The elbow manifold would be less obvious but I think it would still stick out a little.
mgnostic is offline  
Reply Like