edited,
guys, so I have a World Models Midget Mustang (the last model I will buy from them). the slot on this fuselage for the Horizontal Stabilizer has "a ceiling", and the slot has a rather tight fit to the Stab. so if I apply glue to the slot then install the Stab a vary good amount of glue will be pushed away as the Stab is installed,

my friend told me to make divots down the middle of the slot (top & bottom) and use Gorilla glue because it foams,, I didn't like this idea because when this glue foams it has many-many bubbles throughout the glue.

I don't see any other way to install the Stab, can I get some comments about this ?

see page 7 in the link for reference,
A072.pdf

thanks big time guys
Jim