Originally Posted by
jofunk
Hey Bob,
How did you transfer the the plans to the wood for cutting? The parts look nicely cut. I am a big fan of See Temp, but am always looking for new tricks.
Joe
Joe,
Thanks! They are pretty good, I got better as I went along...
I had a buddy who works for the local power company copy the plans and then I cut up the copies into individual parts and used the spray contact cement stuff to stick them to the material to cut them out. I also tended to stay about 1/16 inch outside the outline and then used my benchtop belt sander to sand the parts right to the outline. Thus the outside outline on the parts is better looking than the inside, but soon, nobody will see that...
Bob