RCU Forums - View Single Post - Flite Metal... Help!!!
Thread: Flite Metal... Help!!!
View Single Post
Old 05-26-2020 | 04:40 PM
  #24  
allanflowers's Avatar
allanflowers
 
Joined: Sep 2004
Posts: 1,798
Received 42 Likes on 32 Posts
From: San Diego, CA
Default
Originally Posted by FliteMetal
How close do you want to get to see "The Look Of The Real Thing"? The first image below was a pic taken of
Flite-Metal applied by the Toledo Show Best Of Show winner "just off the roll" with no finishing preparation at
all...that's raw Flite-Metal.












I have other pix of the Flite-Metal surface at about three to four inches...the above were
taken at around 6 inches as the closest.
Amazing work! I've used it a little but your photos really show the tremendous potential. So realistic!
allanflowers is offline  
Reply Like
The following users liked this post:
khodges (08-25-2025)