Hello Guys,

Just a question for you all if you wouldn’t mind or maybe have some ideas.

Let’s start with my setup. I am running a 7014SB Futaba Receiver matched with the Micro 12G Power Expander. My servos are MKS777+ on all surfaces except the throttle which is an MKS1250. (6 total)

My question is, why do my elevator servos (both halfs) have a slight twitch? Almost like they twitch up and down like 1 or 2 clicks of subtrim or so trying to act like they are finding center? It will smooth out without issue after a couple of minutes. But why is my question?

I flew this airplane last year except with a PowerSafe Receiver and no Micro 12G and I had no issue.

Maybe add a capacitor?

Any help would be greatly appreciated.

Thanks

Shane Quale