Ok so here is an update for those of you that are interested.
At the time of programming my elevators, I did not have my ailerons plugged in. In the Micro 12G, the pigtails 1 and 12 must be plugged into the receiver which supplies power to the receiver for redundancy. Channels 1 and 12 are my aileron channels in the 7014SB receiver. Not sure if this is the answer but my twitching on the elevator servos have went away when I plugged in my ailerons.
Seems goofy but maybe this is the answer?
Thanks
Last edited by Shane Quale; 01-26-2021 at 03:44 AM.