There was a delay due to health issues and the death of two family members during the two years of this project.
We are back on track as planned. Gear was resolved last year. With the exception of a resin printer, all of the
equipment to manufacture these is in place in Kentucky.

As for our A6 and the movie 6's...

Our 6 was created from one of the movie 6's. The difference is we created a 3 piece (nose with a fore and aft
fuse section) mold with defined scale features which did not exist on the movie 6's. There were 20 additions
and enhancements to the original movie 6's. These included a molded in vertical fin instead of the balsa built
-up of the movie A6. Internal formers, cradles, and wing go back to Kentucky the last of October.