Just getting started on the ME 109. Downloaded the plans from OZ and cleaned up some scaling issues for ribs, stab, elev. etc. Now one sheet lays out the wing and fuse… the other provides all the cut and past templates for the balsa wood. Got everything ready to cut and will pick up this project after Christmas.



Made a few alterations … love tape. LOL.


Cut and pasted all the templates onto the balsa


Managed to cut the wing ribs out before saying so long until after Christmas


Affixed the wing sheet to the pin board and will assemble the wing when I get back… the 3/8” FUSE balsa is on its way from Balsa USA and should be here next week

Since the Control Line Forum is a bit quite….. figured y’all wouldn’t mind following a build in real-time (sort of)

Merry Christmas Y’all