Hi everyone

I have just joined this forum after purchasing a new 16sz system, as I want to have a go at a twin engine DC3 in the future. I have flown RC models since I was a teenager, but have been trying to learn helicopters, badly for many years. Now moving back to planes and hence the new radio set. I had to change from mode 1 to mode 2 when I started on heli's and do not intend to convert back

I am trying to set up a multi engine mode on a the 16sz so that I can start each engine separately whilst a running engine is held at tick over. The engines are set to channel 3 (left) and channel 9 (right). I have made switch G the controller so that the middle should enable both engines to run normally and by pushing it backwards should only allow control of the left engine and fully forwards the right engine, how do I allocate the channels to the switch please.

Any help would be appreciated.

Clive