Just trying to keep some life in this thread...
Today was the first dry fitting of the suspension system so I could take some measurements. My springs did not arrive yet so they are not mounted.
Pretty pleased with the most of it. Some things need adjusting - the front swing arms need a different angle than the others due to their being on the upward sloping glacis plate but thats no issue.
For some reason I doubted my first measurements and thought that the rear spring retainers were 3 mm too low relative to the retainer on the swinging bit. So Im ade a load of spacers.
But when I mounted them I see that my original measurements were fine. So the spacers have to come out again. What a pain in the ass.
Lower hull is hanging in the garage right now having gotten primed - then I will do the mudguards and assemble the entire lower hull.
Then its onto the upper to finish that.
P