Well good morning guys and gals! Doing a finish up on my wing it’s about ready to install in the fuselage. It’s looking good. Now comes the fun part? Mating that wing assembly. Got to slide it in from right to left. Installed a few reinforcements to insure the wing will be square. Finished the repair on my Veco Chief really Need to rebalance the wing tip to wing tip, then the nose to tail adjustment. Probably need more weight on the right wing. Put a little more off set on my rudder. And my engine is inverted with 2 degrees right off set. When I hang the plane the nose points just a little bit out side. It has solid wire turnbuckle lead outs, my Magishen has the Same, but lately I’ve been going to the .025 cable lead outs. Kinda grounded until my Thumb heals. It’s looking good no Infection and I just missed the bone. Still very sore. AJ.