How much SCFM do you need for the touch up gun.
The one I'm looking at says 11.4 CFM at 23 PSI inlet pressure. Here's the gun I'm looking at: [link=http://www.thetoolwarehouse.net/shop/DEV-FLG635316.html]FinishLine II™ HVLP Gravity Feed Spray Gun [/link] Steve Collins mentioned that one. I've been looking at a lot of those too, and that one looks very nice. I'm taking my time with this and mulling over the compressor and spray gun because I want to buy something nice, that works very well, and that will last a long time. I know I can get a touch up gun for around $40, but I want something a little better than that. I've looked and you could spend over $500 on a gun alone, but I'm not going that far
Thanks again to everyone for their opinions and advice. I'll be making a descision very soon. I hope
Joe