RCU Forums - View Single Post - Recovered UCD3D
View Single Post
Old 12-06-2003 | 04:29 PM
  #14  
visioneer_one
My Feedback: (506)
 
Joined: Dec 2001
Posts: 2,429
Likes: 0
Received 0 Likes on 0 Posts
From: St. Thomas, VIRGIN ISLANDS (USA)
Default RE: Recovered UCD3D

ORIGINAL: seanychen

Hey, I crashed my UCD as well, but not as severe. It gravitated toward the dirt ground when the engine runs out of fuel at a 5' wall entry. It only damage the fuselage forward of the wing LE.

My question is, how do you make sure things are straight when you repair? There is no print to cut the template out of.
I didn't do the repairs. I was planning on pulling my gear and dumping it, but one of my clubmates wanted the wreckage.

the rest, as they say, is the rest.