RCU Forums - View Single Post - Are there different ways to set up Dual elevators w/o y harnesses?

12-14-2003 | 11:40 AM

#8

bdphil

Senior Member

My Feedback: (26)

Joined: May 2002

Posts: 659

Likes: 0

Received 1 Like on 1 Post

From: Dothan, AL

RE: Are there different ways to set up Dual elevators w/o y harnesses?

I second the Hitec digital servo method. I had a dual elevator setup with PMIX on a 6A (and later on an 8U) and it didn't seem like the slave servo was travelling at the same speed as the master. It could have been something incorrect with the way I did the mix, but I thought I read somewhere on Futaba's website that the slave can lag behind in some cases. Anyone ever have that problem?

Ben

Reply Like