For all that are interested here is the link. Link Tool

Maxx:
I'll let this one slip, but dont let it happen again Also please send the check or moey order to the following address............

MR>>C.:
This was the first one where the links were REALLY tight. The elevator servo was having a hard time re-centering because of the high resistance in the links. The Z230 is not CCPM so there are a few links on the elevator channel. After using the toll, it smoothed right out. The tool is even adjustable to get that perfect fit, but you can go to far, so be carefull.

I did find it available at Heliproz For only 13.00.