Guys,

Lets not forget my reply, that I am going to get more then one plane (due to the inexpensive spad cost), as I have found out in the past 4 years of being in this hobby, you never can have enough planes and engines. (wife does not buy this) So for starters where do I get a parts list as well as good directions for the Spad3D. Also setup tips and CG, throw range, dual rate settings for starting 3D, and any helpfull info.

Also, what is the next best plane to learn on, meaning UCD, mini 3D, or any other and what size UCD. I am in this hobby for the long hall and like to have a wish list so if a swap meet comes up or a deal at a RC show, or LHS presents itself I am ready to buy. (again wife does not go along with this theory)

Also, when I was at the SPAD page I saw other profile planes that looked fun, can those be more for fun flying as well as doing some 3D. My club is very active and there is a lot of time that I must fly the pattern and not be in the middle doing 3D (that is when i start to learn). Thanks all this is helping me spend more $$.

Ed